Flexomarine

Single Carcass Hose FLEXOMARINE Tanker End Submarine Hose for use to facilitate lifting up the string
Identified by a double circumferencial white bands at the tanker end
This hose is extremely flexible to support the curvature demanded during offloading
In the hose fittings are welded lifting lugs
Each lug are tested to support Safe Working Loads as follow:
- 12″ = 100 kN
- 16″ = 150 kN
- 20″ = 200 kN
Rated Working Pressure: 15 bar
Minimum Bending Radius: 4D (up to 2D without any permanent deformation)
Electrical Continuity: Discontinuous or as requested
Leak Detection: In case of failure of the primary carcass, a rod installed in each hose end, that is inicially embedded will become visible after the burst of the primary carcass giving confirmation of the failure.

Nominal Bore (mm)	Outside Diameter (mm)		Weight in Air Empty (kg) Weight in Air Full of Sea Water (kg)			Minimum Bending Radius (m)
	D1 END	D2 BODY	9.1m (30ft)	10.7m (35ft)	12.2m (40ft)
150 (6")	290	410	736 208	826 218	911 226	0.6
200 (8")	355	480	1007 290	1133 304	1250 316	0.8
250 (10")	410	540	1285 393	1445 412	1594 430	1.0
300 (12")	480	620	1708 565	1922 599	2123 631	1.2
400 (16")	570	715	2266 807	2547 856	2811 901	1.6
500 (20")	685	830	2883 1028	3253 1096	3600 1160	2.0

Double Carcass Hose