Flexomarine

Single Carcass Hose FLEXOMARINE Tanker End Submarine Hose for use to facilitate lifting up the string
Identified by a double circumferencial white bands at the tanker end
This hose is extremely flexible to support the curvature demanded during offloading
In the hose fittings are welded lifting lugs
Each lug are tested to support Safe Working Loads as follow:
- 12″ = 100 kN
- 16″ = 150 kN
- 20″ = 200 kN
Rated Working Pressure: 19 bar
Minimum Bending Radius: 4D (up to 2D without any permanent deformation)
Electrical Continuity: Discontinuous or as requested
Leak Detection: In case of failure of the primary carcass, a rod installed in each hose end, that is inicially embedded will become visible after the burst of the primary carcass giving confirmation of the failure.

Nominal Bore (mm)	Outside Diameter (mm)		Weight in Air Empty (kg) Weight in Air Full of Sea Water (kg)			Minimum Bending Radius (m)
	D1 END	D2 BODY	9.1m (30ft)	10.7m (35ft)	12.2m (40ft)
150 (6")	300	425	765 205	862 215	952 223	0.6
200 (8")	360	485	1005 285	1132 298	1252 311	0.8
250 (10")	420	560	1340 400	1507 419	1664 437	1.0
300 (12")	490	630	1738 554	1961 588	2170 620	1.2
400 (16")	590	730	2341 797	2640 846	2921 893	1.6
500 (20")	700	850	3003 1038	3393 1106	3759 1171	2.0

Double Carcass Hose