Flexomarine

Single Carcass Hose FLEXOMARINE Tanker End Submarine Hose for use to facilitate lifting up the string
Identified by a double circumferencial white bands at the tanker end
This hose is extremely flexible to support the curvature demanded during offloading
In the hose fittings are welded lifting lugs
Each lug are tested to support Safe Working Loads as follow:
- 12″ = 100 kN
- 16″ = 150 kN
- 20″ = 200 kN
Rated Working Pressure: 21 bar
Minimum Bending Radius: 4D (up to 2D without any permanent deformation)
Electrical Continuity: Discontinuous or as requested
Leak Detection: In case of failure of the primary carcass, a rod installed in each hose end, that is inicially embedded will become visible after the burst of the primary carcass giving confirmation of the failure.

Nominal Bore (mm)	Outside Diameter (mm)		Weight in Air Empty (kg) Weight in Air Full of Sea Water (kg)			Minimum Bending Radius (m)
	D1 END	D2 BODY	9.1m (30ft)	10.7m (35ft)	12.2m (40ft)
150 (6")	300	425	789 211	888 221	981 230	0.6
200 (8")	360	485	1036 293	1167 308	1290 321	0.8
250 (10")	420	560	1381 412	1553 432	1715 451	1.0
300 (12")	490	630	1791 572	2021 606	2237 639	1.2
400 (16")	590	730	2413 822	2722 873	3011 920	1.6
500 (20")	700	850	3096 1070	3498 1141	3875 1207	2.0

Double Carcass Hose